Search scope:
排序: Display mode:
Yong SHUAI, Xinlin XIA, Heping TAN
Frontiers in Energy 2010, Volume 4, Issue 4, Pages 488-495 doi: 10.1007/s11708-010-0007-z
Keywords: Monte Carlo method solar energy radiation performance cavity receiver
Experimental research on ductile fracture criterion in metal forming
Song YU, Weiming FENG
Frontiers of Mechanical Engineering 2011, Volume 6, Issue 3, Pages 308-311 doi: 10.1007/s11465-011-0233-z
Ductile fracture criterion is key limitation parameter in material forming. Accuracy predicting surface and internal failure in plastic deformation process affects on the technology design of workpiece and die greatly. Tension, compression, torsion and shearing test on 45# steel are utilized for providing the experimental values of the critical values at fracture, and 11 widely used ductile fracture criterion are selected to simulate the physical experiments and their relative accuracy for predicting and quantifying fracture initiation sites are investigated. The comparing results show that metal forming process under high triaxiality can be estimated successively using both Normalized Cockcroft-latham and the Brozzo ductile fracture criteria, but the Ayada and general Rice-Tracey model work very well for the low triaxiality cases.
Keywords: ductile fracture criteria metal forming process material experiment stress triaxiality
Research on the equivalent circuit parameter of single linear induction motor
Xu Wei,Sun Guangsheng
Strategic Study of CAE 2008, Volume 10, Issue 8, Pages 76-80
The SLIM parameter has clear error to its real value on the base of the RIM parameter measurement method because it has larger air gap and edge effect. This paper proposes a new scheme suited for SLIM parameter detection. It only needs input total power, phase voltage, phase current, frequency, and then computes primary resistance, primary leakage induction, secondary resistance, secondary leakage induction, air induction and iron loss resistance. The performance analysis of SLIM indicates that this method is very effective and valuable.
Keywords: single linear induction motor open-secondary circuit experiment blocked-secondary circuit experiment
Research on Relationship Between Vibration and Noise of 6203-2RZ Rolling Bearing
Xia Xintao,Wang Zhongyu,Sun Liming,Zhao Lianchun
Strategic Study of CAE 2003, Volume 5, Issue 8, Pages 64-69
Keywords: rolling bearing vibration noise relationship experiment research
Experiment study of a quartz tube falling particle receiver
Tianjian WANG, Fengwu BAI, Shunzhou CHU, Xiliang ZHANG, Zhifeng WANG
Frontiers in Energy 2017, Volume 11, Issue 4, Pages 472-479 doi: 10.1007/s11708-017-0502-6
Keywords: solar thermal electricity central receiver particle receiver experimental research
Shale reservoir network fracturing technology research and experiment
Jia Changgui,Li Shuangming,Wang Haitao, Jiang Tingxue
Strategic Study of CAE 2012, Volume 14, Issue 6, Pages 106-112
Keywords: shale reservoir network fracturing
Development and Experiment Research of the Postprocessor for Parallel Kinematic Machine Tools
Li Tiemin,Ye Peiqing,Wang Jinsong
Strategic Study of CAE 2003, Volume 5, Issue 12, Pages 80-86
Keywords: parallel kinematic machine tools postprocessing algorithm postprocessor
Design and experiment of a novel pneumatic soft arm based on a deployable origami exoskeleton
Frontiers of Mechanical Engineering 2023, Volume 18, Issue 4, doi: 10.1007/s11465-023-0770-2
Keywords: pneumatic soft arm soft airbag deployable origami exoskeleton bistable characteristics cargo-loading capacity
Frontiers of Environmental Science & Engineering 2023, Volume 17, Issue 11, doi: 10.1007/s11783-023-1734-9
● Photochemical conversion of chlorobenzene (CB) on α-Fe2O3 was evaluated.
Keywords: Photochemical conversion Chlorobenzene α-Fe2O3 PCDD/Fs Mineral particulate
Biaxial tensile-compressive experiment of concrete at high temperatures
SONG Yupu, ZHANG Zhong, QING Likun, YU Changjiang
Frontiers of Structural and Civil Engineering 2007, Volume 1, Issue 1, Pages 94-98 doi: 10.1007/s11709-007-0009-z
Keywords: increase Offshore Engineering temperature relationship addition
The Research on Measurement of Drift in the Evaluation Conclusion of Single Method
Chen Guohong,Li Meijuan,Chen Yantai
Strategic Study of CAE 2004, Volume 6, Issue 3, Pages 58-63
Keywords: comprehensive evaluation methods computer simulation experiment measurement of drift
He Guangyi,Duan Changyan,Jing Shan,Wang Taichao
Strategic Study of CAE 2003, Volume 5, Issue 9, Pages 43-48
Keywords: engineering water-pressure blasting simulation experiment energy utilization ratio
Zhijie HUANG, Xiaodan REN, Zuyu CHEN, Daosheng LING
Frontiers of Structural and Civil Engineering 2019, Volume 13, Issue 6, Pages 1350-1362 doi: 10.1007/s11709-019-0559-x
Keywords: underwater explosion centrifuge experiment shock load dynamic response accumulated shock impulse
Liu Youping,Li Yi,Zhang Pijie,He Guangyi
Strategic Study of CAE 2008, Volume 10, Issue 9, Pages 39-46
Keywords: engineering water-pressure blasting energy conservation environmental protection stimulant experiment
Ruan Jing and Hu Feng
Strategic Study of CAE 2012, Volume 14, Issue 5, Pages 57-61
The foundation of the middle pylon of Taizhou Bridge is located above the overlying deposit with the height of 200 m in the water. The round rectangular caisson foundation with the plane dimension of 58 m×44 m and the height of 76 m is employed. To verify the safety and stability of the middle pylon of Taizhou Bridge, a physics model with the scale of 1∶100 to the real structure is built up. The ultimate bearing capacity of the caisson foundation and the influence of sinking depth, soil moisture content, and the side wall friction on the bearing capacity are obtained.
Keywords: bearing capability of caission foundation Taizhou Bridge physics model experiment
Title Author Date Type Operation
Numerical simulation and experiment research of radiation performance in a dish solar collector system
Yong SHUAI, Xinlin XIA, Heping TAN
Journal Article
Experimental research on ductile fracture criterion in metal forming
Song YU, Weiming FENG
Journal Article
Research on the equivalent circuit parameter of single linear induction motor
Xu Wei,Sun Guangsheng
Journal Article
Research on Relationship Between Vibration and Noise of 6203-2RZ Rolling Bearing
Xia Xintao,Wang Zhongyu,Sun Liming,Zhao Lianchun
Journal Article
Experiment study of a quartz tube falling particle receiver
Tianjian WANG, Fengwu BAI, Shunzhou CHU, Xiliang ZHANG, Zhifeng WANG
Journal Article
Shale reservoir network fracturing technology research and experiment
Jia Changgui,Li Shuangming,Wang Haitao, Jiang Tingxue
Journal Article
Development and Experiment Research of the Postprocessor for Parallel Kinematic Machine Tools
Li Tiemin,Ye Peiqing,Wang Jinsong
Journal Article
Design and experiment of a novel pneumatic soft arm based on a deployable origami exoskeleton
Journal Article
Atmospheric heterogeneous reaction of chlorobenzene on mineral -FeO particulates: a chamber experiment
Journal Article
Biaxial tensile-compressive experiment of concrete at high temperatures
SONG Yupu, ZHANG Zhong, QING Likun, YU Changjiang
Journal Article
The Research on Measurement of Drift in the Evaluation Conclusion of Single Method
Chen Guohong,Li Meijuan,Chen Yantai
Journal Article
Research and Application of Engineering Water-pressure Blasting for Economizing Energy and Environmental
He Guangyi,Duan Changyan,Jing Shan,Wang Taichao
Journal Article
Centrifuge experiment and numerical analysis of an air-backed plate subjected to underwater shock loading
Zhijie HUANG, Xiaodan REN, Zuyu CHEN, Daosheng LING
Journal Article
New stage of the research and application of the technology about engineering blasting energy conservation
Liu Youping,Li Yi,Zhang Pijie,He Guangyi
Journal Article